- TOSHIBA Internal Modem User's Guide V.9256K

51
5.375 x 8.375 ver 2.4.0
Chapter 4
AT Commands
In most cases, you will not need to type AT commands
manually. However, there may be some occasions when you
will need to do so.
This chapter describes AT commands for data mode. Fax
commands are issued by application software.
AT command formats
The format for entering AT commands is:
ATXn
where X is the AT command, and n is the specific value for
some of the commands. After you type in the command,
press
Enter.
Any command issued is acknowledged with a response in
either text or numeric values known as result codes.
All commands and command-values accepted by the modem
are described in this section; any entry other than those listed
results in an error.
If no value is entered for n, then the command defaults to a
value of n=0.