User manual Owner manual

Atop Industrial Wireless Access Point
AW5500
User Manual V. 1.3
72
 On operation mode choose “Regular AP” (if the device is not in factory default).
 Go to Wireless → Basic Settings; here you can change the Network Name (SSID) to
your preferred name, you might want to first click on “Scan network” to find whether
there are neighbors with a name matching yours (this is done for preventing any conflict
over networks).
 At this point you may decide to change other settings such as the Wireless Mode and
whether to have Automatic Channel Selection.
 Next go to Security Settings, and on Security Mode choose which security protocol will
be used in the network. We strongly recommend not leaving this section as disabled.
 On LAN & WLAN Interfaces, enter the IP Address, Subnet Mask, Default Gateway,
and DNS servers used (if any), according to your network configuration.
 Click “Apply”, and wait for the changes to take effect. You may also want to Save
Settings afterwards just in case you need these configurations in the future.