User's Manual

Wireless Resident Monitoring

Solutions

Asset Tracking Device

Operational Instructions

The HomeFree system is designed to monitor special needs individuals in the

care center environment. The ATT (Asset Tracking Tag) is one of the many

unique elements of this system.

The ATT is a transmitter that is designed for installation on material assets

such as computers and printers located within the monitored area. When the

monitored item is in motion, the ATT transmits a signal that enables the item

to be tracked. The ATT is not for use outside the monitored area.

LED Indicator

PAGE 1
Wireless Resident Monitoring Solutions Asset Tracking Device Operational Instructions The HomeFree system is designed to monitor special needs individuals in the care center environment. The ATT (Asset Tracking Tag) is one of the many unique elements of this system. The ATT is a transmitter that is designed for installation on material assets such as computers and printers located within the monitored area. When the monitored item is in motion, the ATT transmits a signal that enables the item to be tracked.
PAGE 2
Activating the Asset Tracking tag: The ATT is turned off by the manufacturer before shipment and must be activated before use. To activate, install the rear tamper plate onto the item that requires tracking. Click the ATT onto the rear tamper plate; the LED indicator flashes for 3 seconds indicating that the ATT has been activated successfully.
PAGE 3
FCC Notices Note: The following is applicable only to the 318MHz version of this product. FCC ID: QUX-ATT-830 FEDERAL COMMUNICATIONS COMMISSION (FCC) Part 15 STATEMENT The equipment complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.