Specifications

OPERATION
Starting a cold engine
1.Set the parking brake.
2.Turn the fuel cock to “ON”
3.Turn the engine stop switch to “RUN”
4.Turn the main switch to “ON”
5.Shift the transmission gear to neutral.
6.Push down the choke lever to the end.
7.Complete close the throttle lever.
8.Push the start switch to crank the engine
9.Pull up the chock lever to the middle posi-
tion (warming up position.)until the engine
runs then release the start button. If the en
gine fails to start, release the start button,
then push it again. Each cranking should
not be more than 10 seconds.
10.Keep warming up the engine for 5 min.then
pull up the choke lever to top.
WARNING
Indicates a potential hazard that could re-
sult in serious injury or death
WARNING
POTENTIAL HAZARD
Operating ATV without being familiar with
all controls.
W
HAT CAN HAPPEN
Loss of control, which could cause an
accident or injury.
H
OW TO AVOID THE HAZARD
Read this manual carefully. If you don’t
understand any control or function, ask
your dealer.
32