Specifications

3. Place an container under the engine.
4. Remove the dipstick and drain bolt to drain
the oil
5. Check the O-ring and replace if damaged.
6.Install the drain bolt and tighten to
specification.
7. Fill the engine with oil and equip the
dipstick.
8. Warm up the engine for several minutes at
idle speed. Inspect oil leakage while warming
up.
Drive chain
Drive chain inspection
1. Place the ATV on a level sarface.
2. Check the amount of chain slack by mov-
ing the vehicle slightly forward to gain slack
at the top side of the chain.
3. The chain should have 6-12mm deflection.
Engine oil
Engine oil level measurement
1.Place the ATV on a level surface.
2.Warm up the engine for several minutes and
stop it.
3. Remove the dipstick and wipe it off with a
clean rag. Insert the dipstick in the filler
holewithout screwing it in.
4. Remove the dipstick and check the oil
level.
5. The oil level should be between the maxi-
mum and minimum marks. If the level is low,
add oil to raise it to the proper level.
Engine oil replacement
1. Place the ATV on a level position.
2. Warm up the engine for several minutes
and stop it.
44