User guide

Dante Controller User Guide

-36-

Subscription is OK and audio should be flowing

No subscription, or a subscription error

Subscription is via unicast connection

Subscription is via multicast connection

A particular subscription may have several symbols in its Status column. Common status icon

combinations and their meanings are as follows:

A Unicast device successfully subscribed to a

transmitter, and audio is present on the

channel

Redundant device successfully subscribed on

both primary and secondary to the transmitter

via unicast

Redundant device successfully subscribed on

both primary and secondary to the transmitter

via multicast

Redundant device successfully subscribed on

primary only to the transmitter via unicast. This

is typical when the secondary interface is not

connected

Available Channels

The Available Channels view on the right side of the tab lists the devices and advertized channels

available on the network. Devices that are grayed out indicate that this receiver cannot subscribe to those

channels or devices. This is typically because of a mismatch in parameters (e.g. sample rate

incompatibility etc.), or because a device cannot route audio to itself.

Subscribing to Audio Channels in the Device View

Subscriptions are created by selecting a channel from the Available Channels list in the right-hand pane of

the Receive Tab, then dragging and dropping it onto the appropriate receive channel in the left-hand pane of

the Receive Tab.

Multiple channels can be selected and then dragged and dropped onto the Receive Channels Tab to make

several subscriptions simultaneously.

Changing Rx channel labels in the Receive Tab

Rx channel labels can be changed by double clicking on the channel label and typing in a new value.

Transmit Tab

The Transmit tab is used to inspect and modify the transmit configuration of a device.