User guide

Dante Controller User Guide

-42-

n Latency setting

n Any existing audio routes

Supported devices allow you to 'Clear Config' instead of Factory Reset. Clear Config wipes the same

configuration settings listed above, but allows you to optionally keep the IPsettings (i.e. retain the Dante

Redundancy settings, and any static IP addresses currently configured in the Network Config tab).

A reboot is required after clearing the configuration for the changes to take effect. Some devices will allow

you to automatically reboot after clearing the configuration. If this option is not available, a manual reboot is

required.

Network Config Tab

Use the Network Config Tab to toggle supported devices between Redundant and Switched modes, and to

specify static IP addresses for a device's Ethernet ports.