Specifications
page 4
Quick Install Information
The Epicenter InDash needs to be installed in the signal path between
a source unit and an external amplier(s). Although it can be installed
after an equalizer, it must be installed BEFORE A CROSSOVER.
Once this is done, you need to hook up + 12 volt power, -12 volt
ground, remote turn-on, and connect the illumination wire. If you need
to know more, then read on. Heck, if you don’t think you need to know
more, you should still read on, because you can never know too much.
FACTORY SETTINGS
Shipped Options Page #
Para-BASS
Frequency Center 40Hz 27Hz-63Hz 9
Para-BASS Bandwidth Wide Range from 30Hz-250Hz 9
Input Grounding Balanced Unbalanced 7
Ground Isolation Isolated 200ohm or Ground 7
Choice of beverage Micro-brew Latté 16
Note: Moving jumpers or adjusting the Para-BASS controls can
change these congurations.
Figure 1: Basic Epicenter InDash System