User`s manual

H.323 User's Manual 5. Web Management
Version 5.0 111 December 2006
4. From the ‘Profile Preference’ drop-down list, select the preference (1-20) of the current
Profile. The preference option is used to determine the priority of the Profile. Where
‘20’ is the highest preference value. If both IP and Tel profiles apply to the same call,
the coders and other common parameters (noted by an asterisk in the description of
the parameter IPProfile_ID) of the preferred Profile are applied to that call. If the
Preference of the Tel and IP Profiles is identical, the Tel Profile parameters are
applied.
Note: If the coder lists of both IP and Tel Profiles apply to the same call, an
intersection of the coders is performed (i.e., only common coders remain). The order
of the coders is determined by the preference.
5. Configure the Profile’s parameters according to your requirements. For detailed
information on each parameter, refer to the description of the screen in which it is
configured as an individual parameter.
6. From the ‘Coder Group’ drop-down list, select the coder group you want to assign to
that Profile. You can select the gateway’s default coders (refer to Section 5.5.1.3 on
page 73) or one of the coder groups you defined in the Coder Group Settings screen
(refer to Section 5.5.5.1 on page 106).
7. Repeat steps 2 to 6 for the second to fifth IP Profiles (optional).
8. Click the Submit button to save your changes.
9. To save the changes so they are available after a power fail, refer to Section 5.9.2 on
page 193.
Note: In the current version the parameter ‘Signaling DiffServ’ cannot be
configured using Profiles.