User`s manual

Mediant 1000
H.323 User's Manual 112 Document #: LTRT-83401
5.5.6 Configuring the Registration Prefixes
The Gatekeeper Registration Prefixes Table enables the Mediant 1000 to register with a
Gatekeeper by associating dialing plan information with specific digit prefixes.
The Gatekeeper Registration Prefixes Table data is sent when the gateway requests
permission to register with the Gatekeeper. This registration request is triggered by a
gateway reset, or by the user from the Web Interface.
The prefix registration encoding type is configured by the parameter ‘Gateway Registration
Type’ (described in Table 5-4). If ‘Gateway Registration Type’ parameter contains NPI/TON
(GwRegistrType = 3 or 4) the gateway uses the prefixes defined in the ‘Registration
Prefixes’ table to register as ‘PartyNumber’. In this registration mode the ‘Type of Number’
columns are used, to define the prefix’s TON. In other modes (GwRegistrType = 0, 1 or 2),
the TON column is ignored.
For detailed information on the available methods the Mediant 1000 gateway registers with
a Gatekeeper, refer to Section 8.4 on page 263.
You can also configure the Registration Prefixes Table using the ini file parameter
RegistrationPrefix (refer to Section 6.5.7 on page 226).
¾ To configure the Registration Prefixes, take these 4 steps:
1. Open the ‘Registration Prefixes Table’ screen (Protocol Management menu >
Registration Prefixes); the ‘Registration Prefixes Table’ screen is displayed.
Figure 5-23: Registration Prefixes Table Screen
2. Configure the Registration Prefixes according to Table 5-16.
3. Click the Submit button to save your changes or click the Re-Register button to save
your changes and to re-register to the Gatekeeper.
4. To save the changes so they are available after a power fail, refer to Section 5.9.2 on
page 193.