User`s manual

H.323 User's Manual 5. Web Management
Version 5.0 115 December 2006
5.5.7.2 Automatic Dialing
Use the Automatic Dialing Table to define telephone numbers that are automatically dialed
when a specific port is used.
You can also configure the Automatic Dialing table using the ini file parameter
TargetOfChannelX (refer to Section 6.5.9 on page 236).
¾ To configure the Automatic Dialing table, take these 6 steps:
1. Open the ‘Automatic Dialing’ screen (Protocol Management menu > Endpoint
Settings submenu > Automatic Dialing option); the ‘Automatic Dialing’ screen is
displayed.
Figure 5-25: Automatic Dialing Screen
2. In the ‘Destination Phone Number’ field for a port, enter the telephone number to dial.
3. In the ‘Auto Dial Status’ field, select one of the following:
• Enable [1]: When a port is selected, when making a call, the number in the
Destination Phone Number field is automatically dialed if phone is offhooked (for
FXS modules) or ring signal is applied to port (FXO modules).
• Disable [0]: The automatic dialing option on the specific port is disabled (the
number in the Destination Phone Number field is ignored).
• Hotline [2]: When a phone is offhooked and no digit is pressed for
‘HotLineToneDuration’, the number in the Destination Phone Number field is
automatically dialed (applies to FXS and FXO modules).
4. Repeat step 3 for each port you want to use for Automatic Dialing.
5. Click the Submit button to save your changes.
6. To save the changes so they are available after a power fail, refer to Section 5.9.2 on
page 193.
Notes:
• After a ring signal is detected, on an ‘Enabled’ FXO port, the gateway
initiates a call to the destination number without seizing the line. The
line is seized only after the call is answered.
• After a ring signal is detected on a ‘Disabled’ or ‘Hotline’ FXO port, the
gateway seizes the line.