User`s manual

Mediant 1000
H.323 User's Manual 118 Document #: LTRT-83401
5.5.7.5 Caller ID Permissions
The Caller ID Permissions table is used to enable or disable (per port) the Caller ID
generation (for FXS modules) and detection (for FXO modules). If a port isn’t configured,
its Caller ID generation / detection are determined according to the global parameter
‘EnableCallerID’ (described in Table 5-8 on page 86).
You can also configure the Caller ID Permissions table using the ini file parameter
EnableCallerID_X (refer to Section 6.5.9 on page 236).
¾ To configure the Caller ID Permissions Table, take these 5 steps:
1. Open the ‘Caller ID Permissions’ screen (Protocol Management menu > Endpoint
Settings > Caller ID Permissions option); the ‘Caller ID Permissions’ screen is
displayed.
Figure 5-28: Caller ID Permissions Screen
2. In the ‘Caller ID’ field, select one of the following:
• Enable: Enables Caller ID generation (FXS) or detection (FXO) for the specific
port.
• Disable: Caller ID generation (FXS) or detection (FXO) for the specific port is
disabled.
• Empty: Caller ID generation (FXS) or detection (FXO) for the specific port is
determined according to the parameter ‘EnableCallerID’ (described in Table 5-8
on page 86).
3. Repeat Step 2 for each port.
4. Click the Submit button to save your changes.
5. To save the changes so they are available after a power fail, refer to Section 5.9.2 on
page 193.