User`s manual

Mediant 1000
H.323 User's Manual 140 Document #: LTRT-83401
5.6.2 Configuring the Media Settings
Use these menus to set the gateway’s channel parameters. These parameters are applied
to all Mediant 1000 channels.
From the Media Settings page you can define:
 Voice Settings (refer to Section 5.6.2.1).
 Fax / Modem / CID Settings (refer to Section 5.6.2.2 on page 142).
 RTP/RTCP Settings (refer to Section 5.6.2.3 on page 145).
 Hook-Flash Settings (refer to Section 5.6.2.4 on page 147).
 General Media Settings (refer to Section 5.6.2.5 on page 148).
Note s:
• Parameters contained within square brackets are the names used to
configure the parameters via the ini file.
• Channel parameters are changeable on-the-fly. Changes take effect
from next call.
• Several Channels Settings parameters can be configured per call
using profiles (refer to Section 5.5.5 on page 106).
• The parameter ‘Fax Transport Mode’ (Fax / Modem / CID Settings
screen) is overridden by the parameter ‘IsFaxUsed’.
5.6.2.1 Configuring the Voice Settings
¾ To configure the Voice Settings parameters, take these 4 steps:
1. Open the ‘Voice Settings’ screen (Advanced Configuration menu > Media Settings
> Voice Settings option); the ‘Voice Settings’ screen is displayed.
Figure 5-38: Voice Settings Screen
2. Configure the Voice Settings according to Table 5-27.