User`s manual

H.323 User's Manual 5. Web Management
Version 5.0 151 December 2006
4. Select the ‘Protocol Type’ you use. Note that different trunks can be defined with
different protocols (CAS or ISDN variants) on the same gateway (subject to the
constraints in the Mediant 1000 H.323 Release Notes).
Note: When modifying the ‘Protocol Type’ field, the menu is automatically
updated according to the selected protocol (ISDN, CAS or Transparent).
Additional parameters are appropriate to the selected protocol type.
5. Modify the relevant trunk configuration parameters according to your requirements.
6. To configure the different behavior bits, either enter the exact hexadecimal value of
the bits in the field to the right of the relevant behavior parameter, or directly configure
each bit field by completing the following steps:
a. Click the arrow button (-->) to the right of the relevant behavior parameter; a new
window appears.
b. Modify each bit field according to your requirements.
c. Click the Submit button to save your changes.
7. After modifying the parameters:
• To apply the changes to the selected trunk only, click the Apply Trunk Settings
button.
• To apply the changes to all the trunks, click the Apply to all Trunks button.
The screen is refreshed; parameters become read-only (indicated by being grayed);
the Stop Trunk button appears at the bottom of the screen.
8. To save the changes so they are available after a power fail, refer to Section 5.9.2 on
page 193.
Note: Some parameter configuration options require a device reset; when this is
the case, the Web interface prompts the user.
9. To reset the Mediant 1000, refer to Section 5.9.3 on page 195.