User`s manual

Mediant 1000
H.323 User's Manual 154 Document #: LTRT-83401
Table 5-32: E1/T1/J1 Configuration Parameters (continues on pages 152 to 156)
ini File Field Name
Web Parameter Name
Valid Range and Description
ISDNRxOverlap_x
[Enable Receiving of Overlap
Dialing]
Enable / disable Rx ISDN overlap per trunk ID.
0 = Disabled (default).
1 = Enabled.
Note 1: If enabled, the gateway receives ISDN called number that is sent in the
‘Overlap’ mode.
Note 2: The SETUP message to IP is sent only after the number (including the
‘Sending Complete’ Info Element) was fully received (via SETUP and/or
subsequent INFO Q.931 messages).
Note3: The ‘MaxDigits’ parameter can be used to limit the length of the
collected number for gateway ISDN overlap dialing (if sending complete was
not received).
Note 4: If a digit map pattern is defined (DigitMapping), the gateway collects
digits until a match is found (e.g., useful for closed numbering schemes) or until
a timer expires (e.g., useful for open numbering schemes). If a match is found
(or the timer expires), the digit collection process is terminated even if Sending
Complete wasn’t received.
TrunkLifeLineType
Defines the type of trunk lifeline. Short trunks 1-2, 3-4.
0 = Activate lifeline on power down (default)
1 = Activate lifeline on power down or on detection of LAN disconnect
2 = Activate lifeline on power down or on detection of LAN disconnect or loss of
ping
TrunkAdministrativeState
Defines the administrative state of a trunk.
0 = Lock the trunk; stops trunk traffic to configure the trunk protocol type
2 = Unlock the trunk (default); enables trunk traffic
HeldTimeout
For a description of this parameter, refer to Section 6.5.11 page 246.