User`s manual

H.323 User's Manual 5. Web Management
Version 5.0 161 December 2006
¾ To load a configuration file to the VoIP gateway, take these 8
steps:
1. Open the ‘Regional Settings’ screen (Advanced Configuration menu > Regional
Settings); the ‘Regional Settings’ screen is displayed (shown in Figure 5-46).
2. Click the Browse button adjacent to the file you want to load.
3. Navigate to the folder that contains the file you want to load.
4. Select the file, and then click the Open button; the name and path of the file appear in
the field beside the Browse button.
5. Click the Send File button that is next to the field that contains the name of the file you
want to load. An exclamation mark in the screen section indicates that the file’s
loading doesn’t take effect on-the-fly (e.g., CPT file).
6. Repeat steps 2 to 5 for each file you want to load.
7. To save the loaded auxiliary files so they are available after a power fail, refer to
Section 5.9.2 on page 193. (Refer to note below.)
8. To reset the Mediant 1000, refer to Section 5.9.3 on page 195.
Notes:
• Saving a configuration file to flash memory may disrupt traffic on the
Mediant 1000. To avoid this, disable all traffic on the gateway before
saving to flash memory by performing a graceful lock (refer to Section
5.9.1 on page 192).
• A device reset is required to activate a loaded CPT file.