User`s manual

H.323 User's Manual 5. Web Management
Version 5.0 163 December 2006
2. To change the access level of the secondary account (the access level of the primary
account cannot be changed), from the ‘Access Level’ drop-down list, select the new
access level, and then click the button Change Access Level; the new access level is
applied immediately.
3. To change the username of an account, enter the new username in the field ‘User
Name’, and then click the button Change User Name; the new username is applied
immediately and the ‘Enter Network Password’ screen appears (shown in Figure 5-1
on page 57). Enter the updated username in the ‘Enter Network Password’ screen.
Note that the username can be a maximum of 19 case-sensitive characters.
4. To change the password of an account, enter the current password in the field
‘Current Password’, the new password in the fields ‘New Password’ and ‘Confirm New
Password’, and then click the button Change Password; the new password is applied
immediately and the ‘Enter Network Password’ screen appears (shown in Figure 5-1
on page 57). Enter the updated password in the ‘Enter Network Password’ screen.
Note that the password can be a maximum of 19 case-sensitive characters.
Note: A user with a ‘Security Administrator’ access level can change all attributes
for all accounts. Users with an access level other than ‘Security
Administrator’ can only change their own password and username.
5.6.7.2 Configuring the Web and Telnet Access List
Use this screen to define up to ten IP addresses that are permitted to access the gateway’s
Web and Telnet interfaces. Access from an undefined IP address is denied. This security
feature is inactive (the gateway can be accessed from any IP address) when the table is
empty.
The Web and Telner Access List can also be defined using the ini file parameter
WebAccessList_x (refer to Section 6.5.3 on page 222).
¾ To manage the Web & Telnet access list, take these 4 steps:
1. Open the ‘Web & Telnet Access List’ screen (Advanced Configuration menu >
Security Settings > Web & Telnet Access List option); the ‘Web & Telnet Access
List’ screen is displayed.
Figure 5-48: Web & Telnet Access List Screen