User`s manual

H.323 User's Manual 5. Web Management
Version 5.0 173 December 2006
Note: If you clear a checkbox and then click Submit, all settings in the same row
revert to their defaults.
Table 5-37: SNMP Managers Table Parameters
Parameter Description
Checkbox
[SNMPManagerIsUsed_x]
Up to five parameters, each determines the validity of the parameters (IP
address and port number) of the corresponding SNMP Manager used to receive
SNMP traps.
Checkbox cleared [0] = Disabled (default)
Checkbox selected [1] = Enabled
IP Address
[SNMPManagerTableIP_x]
Up to five IP addresses of remote hosts that are used as SNMP Managers. The
device sends SNMP traps to these IP addresses.
Enter the IP address in dotted format notation, for example 108.10.1.255.
Trap Port
[SNMPManagerTrapPort_x]
Up to five parameters used to define the Port numbers of the remote SNMP
Managers. The device sends SNMP traps to these ports.
Note: The first entry (out of the five) replaces the obsolete parameter
SNMPTrapPort.
The default SNMP trap port is 162
The valid SNMP trap port range is 100 to 4000.
Trap Enable
[SNMPManagerTrapSending
Enable_x]
Up to five parameters, each determines the activation/deactivation of sending
traps to the corresponding SNMP Manager.
Disable [0] = Sending is disabled
Enable [1] = Sending is enabled (default)