User`s manual

H.323 User's Manual 5. Web Management
Version 5.0 177 December 2006
5.7 Status & Diagnostics
Use this menu to view and monitor the gateway’s channels, Syslog messages, hardware /
software product information, and to assess the gateway’s statistics and IP connectivity
information.
5.7.1 Gateway Statistics
Use the screens under Gateway Statistics to monitor real-time activity such as IP
Connectivity information, call details and call statistics, including the number of call
attempts, failed calls, fax calls, etc.
Note: The Gateway Statistics screens don’t refresh automatically. To view
updated information, re-access the screen you require.
5.7.1.1 IP Connectivity
The IP Connectivity screen provides you with online read-only network diagnostic
connectivity information on all destination IP addresses configured in the Tel to IP Routing
table (refer to Section 5.5.4.2 on page 98).
Notes:
• This information is available only if the parameter
AltRoutingTel2IPEnable (described in Table 5-13) is set to 1 (Enable)
or 2 (Status Only).
• The information in columns ‘Quality Status’ and ‘Quality Info.’ (per IP
address) is reset if two minutes elapse without a call to that
destination.
¾ To view the IP connectivity information, take these 2 steps:
1. Set the parameter 'Enable Alt Routing Tel to IP' (or ini file parameter
AltRoutingTel2IPEnable) to 'Enable' (1) or 'Status Only' (2). To configure this
parameter, refer to Section 5.5.4.1 on page 96.
2. Open the ‘IP Connectivity’ screen (Status & Diagnostics menu > Gateway Statistics
submenu > IP Connectivity); the ‘IP Connectivity’ screen is displayed (Figure 5-55).