User`s manual

Mediant 1000
H.323 User's Manual 206 Document #: LTRT-83401
b. Click the Remove Module button; a message box appears requesting you to
confirm module removal.
Figure 5-81: Confirmation Message Box after Clicking Remove Module Button
c. Click OK to confirm module removal; after a few seconds, the module is
"removed" and the module status indicator is grayed. The name of the module is
suffixed with the word 'Reserved'.
Figure 5-82: Module Removed Indicated by "Reserved"
d. You can now physically remove the module (refer to Section 3.5.1 on page 42).
2. Insert the replaced module by performing the following:
e. Physically insert the replaced module (refer to Section 3.5.1 on page 42).
a. On the Home page, click the top border line pertaining to the module that you
want to replace; the Insert Module button appears.
Figure 5-83: Insert Module Button Appears when Clicking Module Name
b. Click the Insert Module button; a message appears informing you that this may
take a few seconds.When the message disappears, the module is inserted
indicated by the disappearance of the 'Reserved' word from the module's name.