User`s manual

Mediant 1000
H.323 User's Manual 222 Document #: LTRT-83401
6.5.3 Web and Telnet Parameters
Table 6-3: Web and Telnet Parameters (continues on pages 222 to 223)
ini File Field Name
Web Parameter Name
Valid Range and Description
WebAccessList_x
Defines up to ten IP addresses that are permitted to access the gateway’s Web
and Telnet interfaces. Access from an undefined IP address is denied. This
security feature is inactive (the gateway can be accessed from any IP address)
when the table is empty.
For example:
WebAccessList_0 = 10.13.2.66
WebAccessList_1 = 10.13.77.7
The default value is 0.0.0.0 (the gateway can be accessed from any IP
address).
For defining the Web and Telnet Access list using the emedded Web server,
refer to Section
5.6.7.2 on page 163.
WebRADIUSLogin
For a description of this parameter, refer to Table
5-35 on page 168.
DisableWebTask
0 = Enable Web management (default).
1 = Disable Web management.
ResetWebPassword
Resets the username and password of the primary and secondary accounts to
their defaults.
0 = Password and username retain their values (default).
1 = Password and username are reset (for the default username and password,
refer to Table
4-1 on page 47).
Note: The username and password cannot be reset from the Web (i.e., via
AdminPage or by loading an ini file).
DisableWebConfig
0 = Enable changing parameters from Web (default).
1 = Operate Web Server in ‘read only’ mode.
HTTPport
HTTP port used for Web management (default = 80)
Telnet Parameters
TelnetServerEnable
For a description of this parameter, refer to Table 5-23 on page 133.
TelnetServerPort
For a description of this parameter, refer to Table 5-23 on page 133.
TelnetServerIdleDisconnect
For a description of this parameter, refer to Table
5-23 on page 133.
Customizing the Web Appearance Parameters
For detailed information on customizing the Web Interface, refer to Section 11.6 on page 307.
UseProductName
0 = Disabled (default).
1 = Enabled.
If enabled, the ‘UserProductNane’ text string is displayed instead of the default
product name.
UserProductName
Text string that replaces the product name.
The default is ‘Mediant 1000’.
The string can be up to 29 characters.
UseWebLogo
0 = Logo image is used (default).
1 = Text string is used instead of a logo image.
If enabled, AudioCodes’ default logo (or any other logo defined by the
‘LogoFileName’ parameter) is replaced with a text string defined by the
‘WebLogoText’ parameter.
WebLogoText
Text string that replaces the logo image.
The string can be up to 15 characters.
LogoWidth
Width (in pixels) of the logo image.
Note: The optimal setting depends on the resolution settings.
The default value is 441, which is the width of AudioCodes’ displayed logo.