User`s manual

H.323 User's Manual 6. ini File Configuration of the Mediant 1000
Version 5.0 229 December 2006
Table 6-7: H.323 Configuration Parameters (continues on pages 226 to 232)
ini File Field Name
Web Parameter Name
*
Valid Range and Description
H323IDString
For a description of this parameter, refer to Table 5-3 on page 64.
SourceEncodeMode
For a description of this parameter, refer to Table
5-3 on page 64.
DestEncodeMode
For a description of this parameter, refer to Table
5-3 on page 64.
PortName_x
This parameter is used to configure the H.323 Port ID table for assigning a
specific ID to each FXS or FXO port.
PortName_<Port> = <H.323 Port ID string>
For example:
PortName_0 = Port ID 1
Note 1: The numbering of channels starts with 0.
Note 2: This parameter can appear up to four times per each module.
For configuring the H.323 Port ID table using the Web interface, refer to
Section
5.5.7.1 on page 114.
RegistrationTime
For a description of this parameter, refer to Table
5-4 on page 70.
ResponseTimeOut
For a description of this parameter, refer to Table
5-4 on page 70.
MaxRetries
For a description of this parameter, refer to Table
5-4 on page 70.
RasSourcePort
Defines a RAS source port from which the gateway sends RAS messages to
the Gatekeeper.
0 = Use dynamic port that is selected by the operating system.
1-65535 = Static port.
The default port is 1719.
RasDestPort
Defines a RAS destination port to which the gateway sends RAS messages
to the Gatekeeper.
0 = Use dynamic port that is selected by the operating system.
1-65535 = Static port.
The default port is 1719.
TimeBetweenGKsLoops
For a description of this parameter, refer to Table
5-4 on page 70.
IsFallbackUsed
For a description of this parameter, refer to Table
5-4 on page 70.
EnableH235Security
For a description of this parameter, refer to Table
5-3 on page 64.
UserName
For a description of this parameter, refer to Table
5-3 on page 64.
Password
For a description of this parameter, refer to Table
5-3 on page 64.
IsFastConnectUsed
For a description of this parameter, refer to Table
5-3 on page 64.
IsTunnelingUsed
For a description of this parameter, refer to Table
5-3 on page 64.
EnableRAI
For a description of this parameter, refer to Table
5-4 on page 70.
RAIHighThreshold
For a description of this parameter, refer to Table 5-4 on page 70.
RAILowThreshold
For a description of this parameter, refer to Table 5-4 on page 70.
RAILoopTime
For a description of this parameter, refer to Table 5-4 on page 70.
TransparentCoderOnDataCall
0 = Use only coders from the coder list (default).
1 = Use transparent coder for data calls.
Transparent coder can be used on data calls. When the gateway receives a
Setup message from the ISDN with TransferCapabilities = data, it can initiate
a Fast Start call using ‘Transparent’ coder (even if the coder is not included
in the coders list). This option is an AudioCodes’ proprietary feature that
requires the use of Fast Start mode and the inclusion of the ‘Transparent’
coder in the coder list of the receiving side.