User`s manual
Mediant 1000
H.323 User's Manual 236 Document #: LTRT-83401
Table 6-8: ISDN and CAS Interworking-Related Parameters (continues on pages 233 to 236)
ini File Field Name
Web Parameter Name
Valid Range and Description
EnablePatternDetector
Enables or disables activation of the Pattern Detector (PD).
Valid options include:
0 = Disable (default).
1 = Enable.
PDPattern
Defines the patterns that can be detected by the Pattern Detector.
The valid range is 0 to 0xFF.
PDThreshold
Defines the number of consecutive patterns to trigger the pattern detection event.
The valid range is 0 to 31. The default is 5.
H323ProgressBehaviour
For a description of this parameter, refer to Table
5-3 on page 64.
6.5.9 Analog Telephony Parameters
Table 6-9: Analog Telephony Parameters (continues on pages 236 to 239)
ini File Field Name
Web Parameter Name
Valid Range and Description
FXONumberOfRings
Defines the number of rings before the FXO gateway answers a call.
The valid range is 0 to 255. The default is 0 seconds.
ChargeCode
ChargeCode_<Charge Code ID> =
<1
st
period end time>,<1
st
period pulse interval>,<1
st
period pulses on answer>,
<2
nd
period end time>,<2
nd
period pulse interval>,<2
nd
period pulses on answer>,
<3
rd
period end time>,<3
rd
period pulse interval>,<3
rd
period pulses on answer>,
<4
th
period end time>,<4
th
period pulse interval>,<4
th
period pulses on answer>
For example:
ChargeCode_1 = 07,30,1,14,20,2,20,15,1,00,60,1
ChargeCode_2 = 05,60,1,14,20,1,00,60,1
ChargeCode_3 = 00,60,1
Note 1: Up to 25 different metering rules can be defined by repeating the
parameter 25 times.
Note 2: To configure the Charge Codes table using the Web interface, refer to
Section
5.5.2.3.1 on page 89.
[Module n]
TargetOfChannelX
n = 0 or 5 (module serial
number)
TargetOfChannel<Port> = <Phone>,<Mode>
Port = 0 to 3.
For example:
[Module 0]
TargetOfChannel0 = 1001,1
TargetOfChannel3 = 911,2
Note 1: The numbering of channels starts with 0.
Note 2: Define this parameter for each gateway port you want to use for
Automatic Dialing.
Note 3: To configure the Automatic Dialing Table using the Web interface, refer to
Section 5.5.7.2 on page 115.