User`s manual

Mediant 1000
H.323 User's Manual 240 Document #: LTRT-83401
6.5.10 Number Manipulation and Routing Parameters
Table 6-10: Number Manipulation and Routing Parameters (continues on pages 240 to 246)
ini File Field Name
Web Parameter Name
Valid Range and Description
TrunkGroup_x
 For digital interfaces:
Defines the Trunk Group table.
TrunkGroup_x = T-U/a-b,c,d
x = Trunk group ID (1 to 99).
T = Starting physical trunk number.
U = Ending physical trunk number.
a = Starting B-channel (from 1).
b = Ending B-channel (up to 31).
Note: To represent all B-channels use a single asterisk instead of ‘a’ and
‘b’.
c = Phone number associated with the first channel (optional).
d = Optional Tel Profile ID (1 to 4).
For example:
TrunkGroup_1 = 0/1-31,1000 (for E1 span).
TrunkGroup_1 = 1/1-31,$$,1.
TrunkGroup_2 = 2/1-24,3000 (for T1 span).
TrunkGroup_1 = 0-7/1-20,1000 (for 8 E1 spans, 20 B-channels).
TrunkGroup_1 = 0-3/*,1000 (for 4 E1 spans, all B-channels).
Note: An optional Tel Profile ID (1 to 9) can be applied to each group of B-
channels.
 For analog interfaces:
TrunkGroup_<Hunt Group ID> = <Starting channel> - <Ending channel>,
<Phone Number>, <Tel Profile ID>
For example:
[Module 0]
TrunkGroup_1 = 1-4,100
[Module 1]
TrunkGroup_2 = 5-8,200,1
Note 1: The numbering of channels starts with 1.
Note 2: ‘Hunt Group ID’ can be set to any number in the range 1 to 99.
Note 3: This parameter can appear up to four times per each module.
Note 4: An optional Tel ProfileID (1 to 9) can be applied to each group of
channels.
ChannelList
This parameter is obsolete; use the parameter TrunkGroup_x instead.
DefaultNumber
For a description of this parameter, refer to Table 5-6 on page 75.
ChannelSelectMode
For a description of this parameter, refer to Table
5-3 on page 64.
TrunkGroupSettings
Defines rules for port allocation for specific Trunk Groups, if such rule doesn’t
exist, the global rule defined by ChannelSelectMode applies.
a, b, c
a = Trunk Group ID number
b = Channel select mode for that Trunk Group.
c = Registration mode for that Trunk Group (Per Endpoint [0] or Per Gateway
[1]). If not configured [-1], the value of AuthenticationMode is used.
Available values are identical to those defined by the ChannelSelectMode
parameter.
AddTrunkGroupAsPrefix
For a description of this parameter, refer to Table
5-13 on page 97.
AddPortAsPrefix
For a description of this parameter, refer to Table 5-13 on page 97.