User`s manual

Mediant 1000
H.323 User's Manual 242 Document #: LTRT-83401
Table 6-10: Number Manipulation and Routing Parameters (continues on pages 240 to 246)
ini File Field Name
Web Parameter Name
Valid Range and Description
PSTNPrefix
PSTNPrefix = a,b,c,d,e
a = Destination Number Prefix
b = Trunk group ID (1 to 99)
c = Source Number Prefix
d = Source IP address (obtained from the Setup message)
e = IP Profile ID (1 to 4)
Selection of trunk groups (for IP to Tel calls) is according to destination number,
source number and source IP address.
Note 1: To support the ‘in call alternative routing’ feature, users can use two
entries that support the same call, but assigned it with a different trunk groups.
The second entree functions as an alternative selection if the first rule fails as a
result of one of the release reasons listed in the AltRouteCauseIP2Tel table.
Note 2: Negative rules can be formed by using a non-existent Trunk group ID.
Note 3: The IP address can include wildcards. The ‘x’ wildcard is used to
represent single digits, e.g., 10.8.8.xx represents all addresses between
10.8.8.10 to 10.8.8.99. The ‘*’ wildcard represents any number between 0 and
255, e.g., 10.8.8.* represents all addresses between 10.8.8.0 and 10.8.8.255.
Note 4: For available notations that represent multiple numbers, refer to
Section
5.5.3.1 on page 95.
Note 5: For configuring the IP to Trunk Group Routing table using the Web
interface, refer to Section
5.5.4.3 on page 100.
PreferRouteTable
For a description of this parameter, refer to Table 5-4 on page 70.
RemovePrefix
For a description of this parameter, refer to Table 5-13 on page 97.
RouteModeIP2Tel
For a description of this parameter, refer to Table 5-15 on page 102.
RouteModeTel2IP
For a description of this parameter, refer to Table 5-14 on page 100.
SwapRedirectNumber
For a description of this parameter, refer to Table 5-21 on page 126.
Prefix2RedirectNumber
For a description of this parameter, refer to Table 5-21 on page 126.
EnableNumberType&Plan
0 = Disable (default)
1 = Enable
If enabled, Numbering Type and Plan parameters are taken from H.225 Setup
message and used in outgoing Q.931 ISDN Setup message (for IPÆ PSTN
calls).
If disabled, ‘Unknown’ is sent in Q.931 ISDN Setup or as configured in number
manipulation tables.