User`s manual

H.323 User's Manual 8. Telephony Capabilities
Version 5.0 277 December 2006
3. In the ‘Tel to IP Routing’ screen, enter 20 in the ‘Destination Phone Prefix’ field, and
the IP address of the FXO Mediant 1000 gateway (10.1.10.2) in the field ‘IP Address’.
Note: In remote extensions, for the transfer to function, hold must be disabled on
the FXS (i.e., Enable Hold = 0).
8.13.5.4 FXO Mediant 1000 Configuration (using the Embedded Web Server)
¾ To configure the FXO Mediant 1000, take these 4 steps:
1. In the ‘Trunk Group Table' screen, assign the phone numbers 200 to 207 for the
gateway’s endpoints.
2. In the ‘Automatic Dialing’ screen, enter the phone numbers of the FXS Mediant 1000
gateway in the ‘Destination Phone Number’ fields. When a ringing signal is detected at
port #1, the FXO module automatically dials the number ‘100’.
3. In the ‘Tel to IP Routing’ screen, enter 10 in the ‘Destination Phone Prefix’ field, and
the IP address of the FXS Mediant 1000 gateway (10.1.10.3) in the field ‘IP Address’.
4. In the ‘Protocol Management’ screen, set the parameter ‘
Dialing Mode’ to ‘Two Stage’
(
IsTwoStageDial=1).