User`s manual

H.323 User's Manual 9. Networking Capabilities
Version 5.0 289 December 2006
9.10.3.1 Integrating Using the Embedded Web Server
¾ To integrate the Mediant 1000 into a VLAN and multiple IPs
network using the Embedded Web Server, take these 7 steps:
1. Access the Embedded Web Server (Section 5.3 on page 57).
2. Use the Software Upgrade Wizard (Section 5.8.1 on page 184) to load and burn the
firmware version to the Mediant 1000 (VLANs and multiple IPs support is available
only when the firmware is burned to flash).
3. Configure the VLAN parameters by completing the following steps:
• Open the ‘VLAN Settings’ screen (Advanced Configuration menu > Network
Settings > VLAN Settings option); the ‘VLAN Settings’ screen is displayed.
• Modify the VLAN parameters to correspond to the values shown in Figure 9-2.
Figure 9-2: Example of the VLAN Settings Screen
• Click the Submit button to save your changes.
4. Configure the multiple IP parameters by completing the following steps:
• Open the ‘IP Settings’ screen (Advanced Configuration menu > Network
Settings > IP Settings option); the ‘IP Settings’ screen is displayed.
• Modify the IP parameters to correspond to the values shown in Figure 9-3. Note
that the OAM, Control and Media Network Settings parameters appear only after
you select the options ‘Multiple IP Networks’ or 'Dual IP' in the field ‘IP
Networking Mode’.
Note: Configure the OAM parameters only if the OAM networking parameters are
different from the networking parameters used in the Single IP Network
mode.