User`s manual

Mediant 1000
H.323 User's Manual 290 Document #: LTRT-83401
Figure 9-3: Example of the IP Settings Screen
• Click the Submit button to save your changes.
5. Configure the IP Routing table by completing the following steps (the IP Routing table
is required to define static routing rules for the OAM and Control networks since a
default gateway isn’t supported for these networks):
• Open the ‘IP Routing Table’ screen (Advanced Configuration menu > Network
Settings > IP Routing Table option); the ‘IP Routing Table’ screen is displayed.
Figure 9-4: Example of the IP Routing Table Screen
• Use the ‘Add a new table entry’ pane to add the routing rules shown in Table 9-3
below.
Table 9-3: Example of IP Routing Table Configuration
Destination IP
Address
Destination Mask
Gateway IP
Address
Hop Count
Network
Type
130.33.4.6 255.255.255.255 10.32.0.1 20 Control
83.4.87.6 255.255.255.0 10.31.0.1 20 OAM
• Click the Submit button to save your changes.
6. Save your changes to flash so they are available after a power fail, refer to Section
5.9.2 on page 193.
7. Reset the gateway (refer to Section 5.9.3 on page 195).