User`s manual

Mediant 1000
H.323 User's Manual 308 Document #: LTRT-83401
Figure 11-7: Image Download Screen
4. Click the Browse button in the Send Logo Image File from your computer to the
device box. Navigate to the folder that contains the logo image file you want to load.
5. Click the Send File button; the file is sent to the device. When loading is complete, the
screen is automatically refreshed and the new logo image is displayed.
6. Note the appearance of the logo. If you want to modify the width of the logo (the
default width is 339 pixels), in the 'Logo Width' field, enter the new width (in pixels),
and then click the Set Logo Width button.
7. To save the image to flash memory so it is available after a power fail, refer to Section
5.9.2 on page 193.
The new logo appears on all Web Interface screens.
Tip: If you encounter any problem during the loading of the files, or you want to
restore the default images, click the Restore Default Images button.
¾ To replace the default logo with your own corporate image via the
ini file, take these 2 steps:
1. Place your corporate logo image file in the same folder as where the device’s ini file is
located (i.e., the same location defined in the BootP/TFTP configuration utility). For
detailed information on the BootP/TFTP, refer to Appendix C on page 381.
2. Add/modify the two ini file parameters in Table 11-3 according to the procedure
described in Section 6.2 on page 209.
Note: Loading the device’s ini file using the ‘Configuration File’ screen in the Web
interface doesn’t load the corporate logo image files.