User`s manual

Mediant 1000
H.323 User's Manual 338 Document #: LTRT-83401
Figure 13-15 shows an advanced example of an access list definition via ini file:
Figure 13-15: Advanced Example of an Access List Definition via ini File
[ ACCESSLIST ]
FORMAT AccessList_Index = AccessList_Source_IP, AccessList_Net_Mask,
AccessList_Start_Port, AccessList_End_Port, AccessList_Protocol,
AccessList_Packet_Size, AccessList_Byte_Rate, AccessList_Byte_Burst,
AccessList_Allow_Type;
AccessList 10 = 10.0.0.0, 255.0.0.0, 0, 65535, any, 0, 40000, 50000, allow ;
AccessList 15 = 10.31.4.0, 255.255.255.0, 4000, 9000, any, 0, 0, 0, allow ;
AccessList 20 = 0.0.0.0, 0.0.0.0, 0, 65535, any, 0, 0, 0, block;
[ \ACCESSLIST ]
Explanation of the example access list:
This access list consists of three rules:
 Rule #10: traffic from the subnet 10.xxx.yyy.zzz is allowed if the traffic rate does not
exceed 40 KB/s.
 Rule #15: if a packet didn't match rule #10, that is, the excess traffic is over 40 KB/s,
and coming from the subnet 10.31.4.xxx to ports 4000 to 9000, then it is allowed.
 Rule #20: all other traffic (which didn't match the previous rules), is blocked.
The internal firewall can also be configured via the Embedded Web Server (refer to Section
5.6.7.3 on page 164).