User`s manual

Mediant 1000
H.323 User's Manual 362 Document #: LTRT-83401
Figure 15-1: Example of Entries in a Device ini file Regarding SNMP
; SNMP trap destinations
; The board maintains a table of trap destinations containing 5 ;rows. The rows
are numbered 0..4. Each block of 4 items below ;apply to a row in the table.
; To configure one of the rows, uncomment all 4 lines in that ;block. Supply an
IP address and if necessary, change the port ;number.
; To delete a trap destination, set ISUSED to 0.
; -change these entries as needed
;SNMPManagerTableIP_0=
;SNMPManagerTrapPort_0=162
;SNMPManagerIsUsed_0=1
;SNMPManagerTrapSendingEnable_0=1
;
;SNMPManagerTableIP_1=
;SNMPManagerTrapPort_1=162
;SNMPManagerIsUsed_1=1
;SNMPManagerTrapSendingEnable_1=1
;
;SNMPManagerTableIP_2=
;SNMPManagerTrapPort_2=162
;SNMPManagerIsUsed_2=1
;SNMPManagerTrapSendingEnable_2=1
;
;SNMPManagerTableIP_3=
;SNMPManagerTrapPort_3=162
;SNMPManagerIsUsed_3=1
;SNMPManagerTrapSendingEnable_3=1
;
;SNMPManagerTableIP_4=
;SNMPManagerTrapPort_4=162
;SNMPManagerIsUsed_4=1
;SNMPManagerTrapSendingEnable_4=1
To configure the trap manger host name, use the parameter
SNMPTrapManagerHostName. For example:
;SNMPTrapManagerHostName = 'myMananger.corp.MyCompany.com’
Note: The same information configurable in the ini file can also be configured via
the acBoardMIB.
15.7.5.3 Configuring Trap Managers via SNMP
The standard snmpTargetMIB interface is available for configuring trap managers.
Note: The acBoard MIB is planned to become obsolete. The only relevant section
in this MIB is the trap sub tree acTrap.