User`s manual

ManualsBrandsAudioCodes ManualsNetworkingMediant 1000

381

382

383

384

385

386

387

388

389

390

Mediant 1000

H.323 User's Manual 382 Document #: LTRT-83401

 Unicast BootP response.

 User-initiated BootP respond, for remote provisioning over WAN.

 Filtered display of BootP requests.

 Location of other BootP utilities that contain the same MAC entity.

 Common log window for both BootP and TFTP sessions.

 Works with Windows™ 98, Windows™ NT, Windows™ 2000 and Windows™ XP.

C.4 Specifications

 BootP standards: RFC 951 and RFC 1542

 TFTP standards: RFC 1350 and RFC 906

 Operating System: Windows™ 98, Windows™ NT, Windows™ 2000 and Windows™

 Max number of MAC entries: 200

C.5 Installation

¾ To install the BootP/TFTP on your computer, take these 2 steps:

1. Locate the BootP folder on the VoIP gateway supplied CD ROM and open the file

Setup.exe.

2. Follow the prompts from the installation wizard to complete the installation.

¾ To open the BootP/TFTP, take these 2 steps:

1. From the Start menu on your computer, navigate to Programs and then click on

BootP.

2. The first time that you run the BootP/TFTP, the program prompts you to set the user

preferences. Refer to the Section C.10 on page 385 for information on setting the

preferences.

C.6 Loading the cmp File, Booting the Device

Once the application is running, and the preferences were set (refer to Section C.10), for

each unit that is to be supported, enter parameters into the tool to set up the network

configuration information and initialization file names. Each unit is identified by a MAC

address. For information on how to configure (add, delete and edit) units, refer to Section

C.11 on page 387.

¾ To load the software and configuration files, take these 4 steps:

1. Create a folder on your computer that contains all software and configuration files that

are needed as part of the TFTP process.

2. Set the BootP and TFTP preferences (refer to Section C.10).

3. Add client configuration for the VoIP gateway that you want to initialize by the BootP,

refer to Section C.11.1.

4. Reset the VoIP gateway, either physically or remotely, causing the device to use

BootP to access the network and configuration information.