User`s manual

H.323 User's Manual C. BootP/TFTP Configuration Utility
Version 5.0 387 December 2006
 Timeout: This specifies the number of seconds that the TFTP utility waits before
retransmitting TFTP messages. This can be left at the default value of 5 (the more
congested your network, the higher the value you should define in these fields).
 Maximum Retransmissions: This specifies the number of times that the TFTP utility
tries to resend messages after timing out. This can be left at the default value of 10
(the more congested your network, the higher the value you should define in these
fields).
C.11 Configuring the BootP Clients
The Clients window, shown in Figure C-4 below, is used to set up the parameters for each
specific VoIP gateway.
Figure C-4: Client Configuration Screen
C.11.1 Adding Clients
Adding a client creates an entry in the BootP Tool for a specific gateway.
¾ To add a client to the list without using a template, take these 3
steps:
1. Click the Add New Client icon
; a client with blank parameters is displayed.
2. Enter values in the fields on the right side of the window, using the guidelines for the
fields in Section C.11.5 on page 389.