User`s manual

H.323 User's Manual E. Accessory Programs and Tools
Version 5.0 401 December 2006
• In the ’Default’ field, enter the default duration this raw data file is repeatedly
played.
• Close the ‘File Data’ window (press the Esc key to cancel your changes); you are
returned to the Prerecorded Tones File(s) screen.
Figure E-6: File Data Window
6. In the ‘Output’ field, specify the output directory in which the PRT file is generated
followed by the name of the PRT file (the default name is prerecordedtones.dat).
Alternatively, use the Browse button to select a different output file. Navigate to the
desired file and select it; the selected file name and its path appear in the ‘Output’
field.
7. Click the Make File(s) button; the Progress bar at the bottom of the window is
activated. The dat file is generated and placed in the directory specified in the ‘Output’
field. A message box informing you that the operation was successful indicates that
the process is completed.
E.2 Call Progress Tones Wizard
This section describes the Call Progress Tones Wizard (CPTWizard), an application
designed to facilitate the provisioning of a Mediant 1000/FXO module by recording and
analyzing Call Progress Tones generated by any PBX or telephone network.
E.2.1 About the Call Progress Tones Wizard
The Call Progress Tones wizard helps detect the Call Progress Tones generated by your
PBX (or telephone exchange) and creates a basic Call Progress Tones ini file (containing
definitions for all relevant Call Progress Tones), providing a good starting point when
configuring an Mediant 1000/FXO module. This ini file can then be converted to a dat file
that can be loaded to the gateway using the TrunkPack Downloadable Conversion utility.
To use this wizard, a Mediant 1000/FXO module connected to your PBX with 2 physical
phone lines is required. This gateway must be configured with factory-default settings and
shouldn’t be used for phone calls during the operation of the wizard.
Note that firmware version 4.2 and above is required on the gateway.
E.2.2 Installation
The CPTWizard can be installed on any Windows 2000 or Windows XP based PC.
Windows-compliant networking and audio peripherals are required for full functionality.
To install the CPTWizard, copy the files from the supplied installation kit to any folder on
your PC. No further setup is required (approximately 5 MB of hard disk space are
required).