User`s manual

Mediant 1000
H.323 User's Manual 402 Document #: LTRT-83401
E.2.3 Initial Settings
¾ To start the CPTWizard, take these 5 steps:
1. Execute the CPTWizard.exe file; the wizard’s initial settings screen is displayed.
Figure E-7: Initial Settings Screen
2. Enter the IP address of the Mediant 1000/FXO module you are using.
3. Select the gateway’s ports that are connected to your PBX, and specify the phone
number of each extension.
4. In the Invalid phone number field, enter a number that generates a ‘fast busy’ tone
when dialed. Usually, any incorrect phone number should cause a ‘fast busy’ tone.
5. Click Next.
Note: The CPTWizard communicates with the FXO module via TPNCP
(TrunkPack Network Control Protocol). If this protocol has been disabled in
the gateway configuration, the CPTWizard doesn’t display the next screen
and an error is reported.