User`s manual

H.323 User's Manual E. Accessory Programs and Tools
Version 5.0 403 December 2006
E.2.4 Recording Screen – Automatic Mode
After the connection to the Mediant 1000/FXO module is established, the recording screen
is displayed.
Figure E-8: Recording Screen –Automatic Mode
¾ To start recording in automatic mode, take these 3 steps:
1. Click the Start Automatic Configuration button; the wizard starts the following Call
Progress Tones detection sequence (the operation takes approximately 60 seconds to
complete):
a. Sets port 1 offhook, listens to the dial tone.
b. Sets port 1 and port 2 offhook, dials the number of port 2, listens to the busy tone.
c. Sets port 1 offhook, dials the number of port 2, listens to the Ringback tone.
d. Sets port 1 offhook, dials an invalid number, listens to the reorder tone.
2. The wizard then analyzes the recorded Call Progress Tones and displays a message
specifying the tones that were detected (by the gateway) and analyzed (by the wizard)
correctly. At the end of a successful detection operation, the detected Call Progress
Tones are displayed in the Tones Analyzed pane (refer to Figure E-9).