User`s manual

H.323 User's Manual H. OSN Server Hardware Installation
Version 5.0 425 December 2006
H OSN Server Hardware Installation
This section is intended for customers who have already purchased the Mediant 1000
Media Gateway and want to install the added Mediant 1000 OSN (Open Solution Network)
Server functionality. The OSN server module hosts third-party VoIP applications such as
IP-PBX, Pre-Paid, and IP-PBX redundancy.
The OSN server is a standalone entity, integrated within the Mediant 1000 gateway, using
a separate Ethernet interface and IP configuration as that used for the gateway.
H.1 Required Working Tools
The following tools are required for installing the OSN Server module:
 Phillips screwdriver
 Flathead screwdriver
 Wire cutter
H.2 OSN Server Installation on the Mediant 1000
The Mediant 1000 OSN Server package is composed of three modules, which need to be
installed in the Mediant 1000:
 Connection (CM) module
 iPMX module
 Hard Drive (HDMX) module
Warning: Before installing the Mediant 1000 OSN Server modules, ensure that the
Mediant 1000 is disconnected from the power supply. These modules
are not hot-swappable and damage to these modules can occur if
replaced under voltage.
These modules are shown in the figures below.
Figure H-1: Connection Module (CM)