User`s manual

H.323 User's Manual H. OSN Server Hardware Installation
Version 5.0 427 December 2006
¾ To install the CM module, take these 5 steps:
1. Place the Mediant 1000, so that the front panel is facing you, as shown in Figure H-4.
2. Using a Phillips screwdriver, remove the black metal cover plate from the slot below
the module labeled CPU, as shown in Figure H-4.
Figure H-4: Mediant 1000 Front Panel View
3. Insert the CM module in the slot below the CPU, with the plain side of the Printed
Circuit Board (PCB) facing up. Make sure the PCB slides into the slot rails. (As the slot
rails are not easily visible, it is important to align the CM with the rails in the slot,
before sliding it in).
Figure H-5: Inserting the CM Module
4. Push the CM module into the slot and press on it firmly to ensure it has been fully
inserted.
5. Using a straight regular screwdriver, tighten the mounting pins.