User`s manual

ManualsBrandsAudioCodes ManualsNetworkingMediant 1000

441

442

443

444

445

446

447

448

449

450

Mediant 1000

H.323 User's Manual 448 Document #: LTRT-83401

I.6.5 Stage 5: Installation

Now you have the boot media which enables the installation of the Mediant 1000 using the

serial connection (terminal) with RS-232 cable.

¾ To complete the installation, take these 7 steps:

1. Connect your Windows™ PC via serial cable to the Mediant 1000.

2. Connect the USB CDROM device via USB cable to the Mediant 1000.

3. Power up the PC.

4. Open the Terminal application on your PC. Create a new connection with the

following settings:

• Connect Port = COM1

• Baudrate = 115200 (bits per second)

• Data Bits = 8

• Parity = None

• Stop Bits = 1

• Flow Control = None

5. Insert the “Boot CD” (created in Stage 3) into the USB CD-ROM.

6. Power up the Mediant 1000.

7. On the Terminal screen, the BIOS phase will start and the Linux

installation will

begin. The installation will uncompress the kernel, load it and its drivers and start the

interactive installation.

Notes:

• After the BIOS phase, some badly formatted text may appear on the

screen.

• From this point on, you should proceed with the screen instructions, as

instructed by your Linux distributor

I.6.6 Additional Linux™ Debian Installation Notes (12)

Please refer to the following notes for the remaining part of the installation.

1. The first interactive screen should be 'Language Selection'. Before you select the

language you wish to use, remove the “Boot CD” and insert the 1st Debian

installation disk. Select the language you wish to use.

2. As you continue with the installation, you should go through the following stages of the

installation:

a. Country selection

b. CROM scan

c. DHCP configuring

3. Configure your network settings manually by selecting the Configure network

manually option. Either:

• the DHCP configuration will fail and a screen enabling you to configure the

network manually will appear,

• go to the Main Installation menu and select the manual network configuration.

Ensure the network is connected and set a Static IP Address and all the other

network parameters.