User`s manual

H.323 User's Manual 4. Getting Started
Version 5.0 49 December 2006
¾ To assign an IP address using BootP, take these 3 steps:
1. Open the BootP application (supplied with the Mediant 1000 software package).
2. Add client configuration for the Mediant 1000, refer to Section C.11.1 on page 387.
3. Use the reset button to physically reset the gateway causing it to use BootP; the
Mediant 1000 changes its network parameters to the values provided by the BootP.
4.2.3 Assigning an IP Address Using the Voice Menu Guidance
Initial configuration of the gateway can be performed using a standard touch-tone
telephone connected to one of the FXS analog ports. The voice menu can also be used to
query and modify basic configuration parameters.
Note: Assigning an IP address using voice menu guidance is only possible when
the Mediant 1000 houses an FXS module (analog).
¾ To assign an IP address using the voice menu guidance, take
these 7 steps:
1. Connect a telephone to one of the FXS ports. Lift the handset and dial ***12345 (three
stars followed by the digits 1, 2, 3, 4, 5).
2. Wait for the 'configuration menu' voice prompt to be played.
3. To change the IP address, press 1 followed by the pound key (#).
• The current IP address of the gateway is played. Press # to change it.
• Dial the new IP address; use the star (*) key instead of dots ("."), e.g.
192*168*0*4 and press # to finish.
• Review the new IP address, and press 1 to save it.
4. To change the subnet mask, press 2 followed by the # key.
• The current subnet mask of the gateway is played. Press # to change it.
• Dial the new subnet mask; e.g. 255*255*0*0 and press # to finish.
• Review the new subnet mask, and press 1 to save it.
5. To change the default gateway IP address, press 3 followed by the # key.
• The current default gateway address of the gateway is played. Press # to change
it.
• Dial the new default gateway address; e.g. 192*168*0*1 and press # to finish.
• Review the new default gateway address, and press 1 to save it.
6. Hang up the handset. Access the gateway's Embedded Web Server with the new IP
address you assigned (refer to Section 5.3 on page 57).
7. Complete the gateway’s configuration and save it to non-volatile memory (refer to
Section 5.9.2 on page 193).