User`s manual

H.323 User's Manual 4. Getting Started

Version 5.0 51 December 2006

2. To access the CLI using the RS-232 port, perform the following:

a. Connect the RS-232 port to your PC (refer to Section 3.4.1 on page 38).

b. Use serial communication software (e.g., HyperTerminal

) to connect to the

Mediant 1000. Set your serial communication software to the following

communications port settings:

♦ Baud Rate: 115,200 bps

♦ Data bits: 8

♦ Parity: None

♦ Stop bits: 1

♦ Flow control: None

The CLI prompt becomes available.

3. Assign an IP address by performing the following:

a. At the prompt, type conf, and then press Enter; the configuration folder is

accessed.

b. To check the current network parameters, at the prompt, type GCP IP, and then

press Enter; the current network settings are displayed.

c. Change the network settings by typing:

SCP IP [ip_address] [subnet_mask] [default_gateway]

For example, ‘SCP IP 10.13.77.7 255.255.0.0 10.13.0.1’. Note: This command

requires you to enter all three network parameters (each separated by a space).

The new settings take effect on-the-fly. Connectivity is active at the new IP address.

d. To save the configuration, at the prompt, type SAR, and then press Enter; the

Mediant 1000 restarts with the new network settings.