User`s manual

H.323 User's Manual 4. Getting Started
Version 5.0 53 December 2006
5. To configure the Tel to IP Routing Table, click the arrow button next to ‘Tel to IP
Routing Table’. For information on how to configure the Tel to IP Routing Table, refer
to Section 5.5.4.2 on page 98.
6. Click the Reset button, and then at the prompt, click OK; the Mediant 1000 applies the
changes and restarts.
You are now ready to start using the VoIP gateway. To prevent unauthorized access to the
Mediant 1000, it is recommended that you change the username and password that are
used to access the Web Interface. Refer to Section 5.6.7.1 on page 162 for details on how
to change the username and password.
Note: The preferred coder is the coder that the Mediant 1000 uses as a first
choice for all connections. If the far end gateway does not use this coder,
the Mediant 1000 negotiates with the far end gateway to select a coder that
both sides can use.
Tip: Once the gateway is configured correctly back up your settings by making
a copy of the VoIP gateway configuration (ini file) and store it in a directory
on your PC. This saved file can be used to restore configuration settings at
a future time. For information on backing up and restoring the gateway’s
configuration, refer to Section 5.6.5 on page 159.