User`s manual

H.323 User's Manual 5. Web Management
Version 5.0 57 December 2006
5.2.2 Limiting the Embedded Web Server to Read-Only Mode
Users can limit access to the Embedded Web Server to read-only mode by changing the ini
file parameter ‘DisableWebConfig’ to 1. In this mode all Web screens, regardless of the
access level used, are read-only and cannot be modified. In addition, the following screens
cannot be accessed: ‘Quick Setup’, ‘Web User Accounts’, ‘Maintenance Actions‘ and all
file-loading screens.
Note 1: Read-only policy can also be applied to selected users by setting the
access level of the secondary account to ‘User Monitor’ (DisableWebConfig
= 0) and distributing the primary and secondary accounts to users
according to the organization’s security policy.
Note 2: When DisableWebConfig is set to 1, read-only privileges are applied to all
accounts regardless of their access level.
5.2.3 Disabling the Embedded Web Server
Access to the Embedded Web Server can be disabled by using the ini file parameter
‘DisableWebTask = 1’. The default is access enabled.
5.3 Accessing the Embedded Web Server
¾ To access the Embedded Web Server, take these 4 steps:
1. Open a standard Web-browsing application such as Microsoft™ Internet Explorer™ or
Netscape™ Navigator™.
2. In the Uniform Resource Locator (URL) field, specify the IP address of the Mediant
1000 (e.g., http://10.1.10.10); the Embedded Web Server’s ‘Enter Network Password’
screen appears, shown in Figure 5-1.
Figure 5-1: Embedded Web Server Login Screen
3. In the ‘User Name’ and ‘Password’ fields, enter the username (default: ‘Admin’) and
password (default: ‘Admin’). Note that the username and password are case-sensitive.
4. Click the OK button; the ‘Quick Setup’ screen is accessed (shown in Figure 4-1 on
page 52).