User`s manual

Mediant 1000
H.323 User's Manual 68 Document #: LTRT-83401
Table 5-3: Protocol Definition, General Parameters (continues on pages 64 to 68)
Parameter Description
UseSourceNumberAsDisp
layName
[Use Source Number as
Display Name]
Applicable to TelÆIP calls.
0 = The Tel Source Number is used as the IP Source Number and the Tel Display
Name is used as the IP Display Name (if Tel Display Name is received). If no
Display Name is received from the Tel side, the IP Display Name remains empty
(default).
1 = If a Tel Display Name is received, the Tel Source Number is used as the IP
Source Number and the Tel Display Name is used as the IP Display Name. If no
Display Name is received from the Tel side, the Tel Source Number is used as the
IP Source Number and also as the IP Display Name.
2 = The Tel Source Number is used as the IP Source Number and also as the IP
Display Name (even if the received Tel Display Name is not empty).
UseDisplayNameAsSourc
eNumber
[Use Display Name as
Source Number]
Applicable to IPÆTel calls.
0 = The IP Source Number is used as the Tel Source Number and the IP Display
Name is used as the Tel Display Name (if IP Display Name is received). If no
Display Name is received from IP, the Tel Display Name remains empty (default).
1 = If an IP Display Name is received, it is used as the Tel Source Number and
also as the Tel Display Name, the Presentation is set to Allowed (0). If no Display
Name is received from IP, the IP Source Number is used as the Tel Source
Number and the Presentation is set to Restricted (1).
Hook-Flash Code to IP
[HookFlashCodeIP]
Defines a digit pattern that is sent to the IP when the gateway detects a Hook-
Flash event from the Tel side. All transport methods are supported: H.245 User
Input, Q.931 Info, and H.245 Signal. When this pattern is detected from the IP
side, a Hook-Flash is generated towards the Tel side.
The valid range is a 25-character string. The default is '!'.