User`s manual

H.323 User's Manual 5. Web Management
Version 5.0 89 December 2006
4. In the Tel to IP Routing table (Section 5.5.4.2 on page 98) assign a charge code rule
to the routing rules you require.
When a new call is established, the Tel to IP Routing table is searched for the
destination IP addresses. Once a route is found, the Charge Code (configured for that
route) is used to associate the route with an entry in the Charge Codes table.
5. Click the Submit button to save your changes.
6. To save the changes so they are available after a power fail, refer to Section 5.9.2 on
page 193.
Table 5-9: Metering Tones Parameters
Parameter Description
Generate Metering Tones
[PayPhoneMeteringMode]
Determines the method used to configure the metering tones that are generated to
the Tel side (FXS modules only).
Disable [0] = Metering tones aren’t generated (default).
Internal Table [1] = Metering tones are generated according to the internal table
configured by the parameter ChargeCode.
RADIUS [2] = N/A.
Note: This parameter is not applicable to the Metering Tones Relay mechanism
(described in Section
12.1 on page 317).
Metering Tone Type
[MeteringType]
Defines the metering tone (12 kHz or 16 kHz) that is detected by FXO modules
and generated by FXS modules.
12 kHz [0] = 12 kHz metering tone (default).
16 kHz [1] = 16 kHz metering tone.
Note: Suitable (12 kHz or 16 KHz) coeff must be used for both FXS and FXO
modules.
Charge Codes Table For detailed information on configuring the Charge Codes Table, refer to Section
5.5.2.3.1 below.
5.5.2.3.1 Charge Codes Table
The Charge Codes table is used to configure the metering tones (and their time interval)
that the FXS module generates to the Tel side. To associate a charge code to an outgoing
Tel to IP call, use the Tel to IP Routing table.
You can also configure the Charge Codes table using the ini file parameter ChargeCode
(refer to Section 6.5.9 on page 236).
¾ To configure the Charge Codes table, take these 6 steps:
1. Access the ‘Metering Tones’ screen (Protocol Management menu > Advanced
Parameters submenu > Metering Tones option); the ‘Metering Tones’ screen is
displayed (Figure 5-11).
2. Open the ‘Charge Codes Table’ screen by clicking the arrow sign (-->) to the right of
the Charge Codes Table label; the Charge Codes Table is displayed.
Figure 5-12: Charge Codes Table Screen