User`s manual

Mediant 1000
H.323 User's Manual 96 Document #: LTRT-83401
For NI-2 and DMS-100 ISDN variants the valid combinations of TON and NPI for calling
and called numbers are (Plan/Type):
 0/0 - Unknown/Unknown
 1/1 - International number in ISDN/Telephony numbering plan
 1/2 - National number in ISDN/Telephony numbering plan
 1/4 - Subscriber (local) number in ISDN/Telephony numbering plan
 9/4 - Subscriber (local) number in Private numbering plan
5.5.4 Configuring the Routing Tables
Use this submenu to configure the gateway’s IPÆTel and TelÆIP routing tables and their
associated parameters:
 General Parameters (refer to Section 5.5.4.1 on page 96)
 Tel to IP Routing Table (refer to Section 5.5.4.2 on page 98)
 IP to Trunk Group Routing (refer to Section 5.5.4.3 on page 100)
 Internal DNS Table (refer to Section 5.5.4.4 on page 103)
 Reasons for Alternative Routing (refer to Section 5.5.4.5 on page 104)
5.5.4.1 General Parameters
Use this screen to configure the gateway’s IPÆTel and TelÆIP routing parameters.
¾ To configure the general parameters under Routing Tables, take
these 4 steps:
1. Open the ‘General Parameters’ screen (Protocol Management menu > Routing
Tables submenu > General Parameters option); the ‘General Parameters’ screen is
displayed.
Figure 5-15: Routing Tables, General Parameters Screen
2. Configure the general parameters under ‘Routing Tables’ according to Table 5-13.
3. Click the Submit button to save your changes.
4. To save the changes so they are available after a power fail, refer to Section 5.9.2 on
page 193.