Specifications

e-mail: [e-mail] voice: 360.854.9559 fax: [phone]
15
Broadcast Tools
®
ACS 8.2 Plus Eight Input, Dual Output StereoMatrix Audio Control Switcher
INSTALLATION
INSTALLATION GUIDELINES
Menu Mode:
The command to enter menu mode starts with an asterisk (“*”) followed by the
device ID (0, ONLY) address as a single decimal digit, then the MM command.
NOTE: Commands typed will NOT be seen, unless you turn “Echo ON” in
HyperTerminal. The menu mode displays advanced configuration parameters. Unit
ID, Baud rate and other configurations are set via the on-board dipswitches (SW 17)
at the front of the unit.
NOTE: The cover must be removed, to gain access to the Dipswitches.
Serial Burst Mode Commands:
Burst mode allows a computer or ASCII terminal to control and interrogate the unit.
This section defines all burst mode commands. Each burst mode command starts
with an asterisk (“*”). Next is a single decimal digit that corresponds to the unit (ID)
address 0-3. Following that are one or more ASCII characters specifying the com-
mand. No carriage-return or line-feed is required to terminate the command except
for those few commands of variable length, if the maximum length is not sent. If
acknowledgements are enabled, successful commands are responded to with “RRR”
while errors get an “EEE” response. The syntax of each command is given below.
The syntax shows the command exactly as it should be sent, except that lower case
characters represent values that should be substituted.
WEBSITE:
Visit our web site for
product updates and
additional information.
Broadcast Tools® ACS 8.2 Plus, v1.8 - Menu
1 - PIP Min 0-2.55 sec Now: 0.02 (sec)
2 - O.C. Mode Now: "Follow"
3 - SS Delay Time (sec) Now: 10
4 - SS Restore Time (sec) Now: 10
5 - Dim (DB) Now: -10
6 - Fade (sec) Now: 5
7 - Relay Pulse (sec) Now: 1.0