User manual

7
GB
Use to adjust the upper temperature limit.
Press the menu key briefly.
The display shows .
Schalten Sie mit das Nachtlicht am Sender ein bzw. aus.
Press the menu key briefly.
The display shows .
Use to switch the vibration alarm on or off.
When the vibration alarm is activated, the receiver vibrates when sounds in the room
being monitored are so loud that the red Sound Level LEDs are activated.
Press the menu key briefly.
The display shows .
Use to set VOX to OFF or adjust the sensitivity to one of 5 levels (5 = highest
sensitivity).
(VOX: Voice Operated Transmission = Sound detection)
The VOX function (sound detection) causes the system to start transmitting automatical-
ly from the transmitter to the receiver immediately a voice or sound is detected. If one of
the five levels has been set, the VOX icon lights up in the display.
If the receiver is operated with battery (without power supply) the display will switch off
after approx. one minute of inactivity, but will switch back on if triggered by the vox
detector in the transmitter or by pressing any button on the receiver.
However if VOX is set to OFF, the display will remain on all the time.
Video/Audio switching
You can manually switch off the display to save battery power. The sound from the baby’s room are
to be heard permanently and the display will automatically switch on again if triggered by the vox
detector.
Press this button briefly.
For switching the display on again press this button again briefly.
Operating the Receiver