User manual

Registration

In delivery state the transmitter is pre−registered at the receiver. If necessary or if a another camera

is added to the system, registration can also be completed manually:

1 Switch the receiver on.

2 Press the menu key repeatedly until [C1] appears in the display.

3 Use the buttons to select the desired camera [C1] ... [C4].

4 Press the button briefly. The Link LED flickers for approx. 10 seconds. During this

time, you must perform steps 5 and 6.

5 Switch the transmitter on (switch set to ON).

6 Press the registration key on the rear of the transmitter. After a

short time the video from the transmitter will appear on the

screen if the registra tion was successful.

If the registration failed, “Out of Range“ appears on the screen.

Multi camera mode

If you registered several cameras (up to 4) to your system, you can select a single camera or switch

to scan mode. In scan mode, the signals from all activated cameras are continuously displayed alter-

nately each for about 10 seconds.

Press this button briefly. The number of the selected camera is shown.

Select another camera or the scan mode by pressing this button repeatedly.

Selecting the cameras for the scan mode

When performing the selection of the camera (see above), you can set by pressing

these buttons for each of the registered cameras, whether it should be assigned to the

scan mode (e. g. “C2 x” = not assigned to the scan mode / “C2 ✔” = assigned to the

scan mode).

For each of the four cameras you can select the features settings individually.

Operating the Receiver

PAIR