Operating instructions

Starting Up

3 Starting Up

Safety notes

a It is essential to read the “General Information" at the beginning of this manual before starting

up.

Checking the package contents

The package contains:

1 Parent unit (receiver) 2 mains adaptor with power cord

1 Baby unit (sender) 2 rechargeable batteries AAA, 750 mAh, NiMH

1 support for parent unit 1 audio cable

1 user manual

Parent unit

1. Remove the battery cover on the back of the parent unit. Insert the rechargeable batteries as mar-

ked on the unit and close the cover again.

2. Attach the transparent stand to the unit. It can be positioned in 2 ways: high position for hanging

the parent’s unit, low position for placing the unit on a flat surface

3. Plug the power cord into the power jack and plug the adaptor plug into a mains power socket.

4. Press and hold down the Power Key to turn the parent unit on if necessary.

The display shows the charging of the batteries.

a Note: Before first use, or if it has been out of use for a long time, the parent unit will need to be

charged for 13 hours. During this time, the parent unit will operate from the power adaptor when

switched on.

Baby unit

1. In event of a power failure, your baby monitor can switch to battery power. It is therefore recom-

mended that you insert non-rechargeable batteries in the baby unit.

2. Remove the battery cover on the back of the baby unit by applying pressure and sliding it down.

Insert 2 alkaline batteries or rechargeable batteries of the type AAA (not provided) as marked on

the unit and close the cover again. Please note, that the baby unit has no charging functionali-

ty, even when the mains adaptor is connected.

3. Plug the power cord into the power input of the baby unit and plug the adaptor plug into a mains

power socket.

4. Press and hold down the Power Key to turn the baby unit on if necessary.

a Note: The baby unit should be placed about 1 m away from the baby‘s cot on a flat

surface.

Never place the baby unit inside the cot, bed or playpen. Make sure the unit, cords and mains

adaptor are out of reach of the baby and other young children. Never place either unit on antique

or polished surfaces to avoid damage from the rubber feet.